131 Photos - Sep 2, 2010
Photo: Photo: Photo: Conduit from main panel, into the ground and out to the workshop.Photo: Photo: Photo: Photo: Zoe's artwork.Photo: Photo: Ground rod & 6 gauge wire outside the shed.Photo: Had to switch out the 30amp breaker for a 20 amp breaker since we ran 12 gauge wire.  I'll need to switch this to a GFCI breaker eventually since code requires a GFCI breaker for any direct burial wire less than 24" deep (we only went 18").Photo: Apparently the hot wire coming from the main panel has to be pigtailed in a 120v setup, not wired directly to the lugs and then using a bridge wire...so I had to switch it up a bit.Photo: Put plastic conduit over some of the 12/2 wire for protection since the walls aren't going to be drywalled and closed in.Photo: Photo: Photo: First two shop lights are up.  Need to put up four more and add cabinets and more shelving yet.Photo: Wired subpanel.  I had to add a ground bar after finding out the ground and neutral wires had to be on isolated bars in a subpanel in a detached structure...and the subpanel only came with the one bar.Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Roof decking is up...felt paper down.Photo: Photo: Photo: Photo: Sheathing up on gables, overhang hung on one side.Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Uploaded by DROID™Photo: Photo: Uploaded by DROID™Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: