76 Photos - Jun 23, 2013
Photo: Photo: Photo: Photo: Video: using super glue to initiate new (conventional) hatch-cover supports, pre-epoxy applicationPhoto: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: 1st sabre saw cut, old deck removal, coaming's not yet been removed (bicycle at ready for quick getaway)Photo: foredeck, initial removalPhoto: Photo: Photo: foredeck completed removal rear to coamingPhoto: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: applying edging to newly renewed deck, initially stretch 3M taped, then web-clamped to tighten glue linePhoto: Photo: (detail) applying edging to newly renewed deck, bevelled end cinched with brass tackPhoto: Photo: detail: deck finish stripPhoto: Photo: deck and trim installed, pending final finish, hatch openings handsawn to remove matching grain plywood intact, centre line established for alignmentPhoto: in a makeshift reconstruction environmentPhoto: Photo: rear hatch iopening, completed matching grain cover web-clamped to preserve camber during epoxy setup (2 layer hatch cover)Photo: Photo: Photo: Photo: Photo: fore hatch opening, awaiting stacked-underside hatch cover mount applicationPhoto: all hands aboard, gang of clamps in aid of stacked-underside hatch cover mount applicationPhoto: Photo: Photo: Photo: Photo: aft hatch opening, awaiting stacked-underside hatch cover mount applicationPhoto: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: Photo: