33 Photos - Nov 10, 2012
Photo: Geometry: It works.Photo: The towers go up to test the holes.Photo: Some scale reference.Photo: Testing ball-chain pulleys.Photo: One completed tower with tensioned chain.Photo: Assembling the towers into the chassis.Photo: The two^H^H^Hthree towers.Photo: The arms installed with the flying platform.Photo: Putting the machine to bed for the night...Photo: Wiring, wiring, wiring.Photo: How to assemble the arms, part 0Photo: How to assemble the arms, part 1Photo: How to assemble the arms, part 2Photo: How to assemble the arms, part 3: A printed plug super-glued into the end, tapped and ready for an extensionPhoto: Photo: How to assemble the arms, part 4: comparison with the tip shankPhoto: How to assemble the arms, part 5Photo: How to assemble the arms, part 6Photo: How to assemble the arms, part 7Photo: How to assemble the arms, part 8Photo: Completed wiring, finished arms.Photo: Borrowed electronics from Mike's Prusa.Photo: Looking down the Bowden cable port.Photo: Drive pulley and stepper.Photo: Arm carriage.Photo: Side view of arm carriage.Photo: Flying platform with Budaschnozzle.Photo: Flying platform with Budaschnozzle.Photo: Idler pulley.Photo: Inside after stain, varnish, and polycarbonate enclosure.Photo: Outside after stain, varnish, and polycarbonate enclosure.Photo: Heated bed PCB heater, and PSU PCB.Photo: Aluminum 6061 sheet, 1/4" x 12" x 12", green PET tape on printing surface from Lulzbot.