Post has attachment

Post has attachment
Has anyone used or seen one of these before, are they any good?
Was thinking one for 2 of my printers
Sadly they are out of stock but I got an email from them saying they are getting more in a few weeks
http://aus3d.com.au/ir-z-probe

Post has attachment

Post has attachment

Post has attachment
Just wanted to say thanks to Filaments Directory and colorFabb for the new filament that arrived at my door. I will put it to good use
Photo

Would like to buy 2 of these. How ?

Post has attachment
Breakout / bridge board Assembled

Photo

Post has attachment
PrintDry Filament Dryer - What do you guys think about this?

Post has attachment

Post has shared content
Interesting... for all of you who are on RAMPS
After working on this on and off for 2 years and a total of 6 iterations., the Re-ARM project is nearing completion. A little present for all the RAMPS users out there.

Re-ARM is basically 32bit Smoothieware on an Arduino MEGA footprint.

Proto custom shield shown (green PCBs) and RAMPS V1.4 (red PCB)



Photo
Wait while more posts are being loaded