Post has attachment
I’ve been dealing with a couple more giveaway rockets. I don’t know their history. Looks like both are based on failed rockets, but there are things I can only guess at. First rocket: There’s a piece of body tube, painted and with a sticker on it, with…
Add a comment...

Post has attachment
Temperature in the mid 70s, clear skies, almost no wind… you sure this is October? I was pushing the button much of the day but snuck in a few rockets of my own, and abdicated close to the end of the launch to prep a couple rockets that needed more time.…
Add a comment...

Post has attachment
If you’re looking for trouble, you might find it in a dollar store. I dragged a piece of ST-7 tube out of the stash. Cut off three pieces, punched a hole in each of two and two in the third. I also had a couple of 18 mm balsa blocks about an inch long in…
Add a comment...

Post has attachment
Yesterday’s weather was just about perfect for flying rockets. Could’ve been five degrees cooler but that’s about it. I was the launch director, though, so I did a lot of pushing the button for other people’s rockets. I brought only one rocket of my own,…
Add a comment...

Post has attachment
I finished putting the Blue Bird Zero together. I’ve forgotten, have I ever used the alternate top piece of the fin alignment tool? The one for narrower tubes? Maybe this was a first. The spirals were pretty tight, so I decided to leave them for the…
Add a comment...

Post has attachment
Look, in my defense, I tested the Testors laquer over the Duplicolor primer. And I tested the Rustoleum 2X black enamel over the Testors laquer over the Duplicolor primer. The one thing I didn’t test was the Krylon clear coat over the Rustoleum 2X black…
Add a comment...

Post has attachment
Hey, did you know Testors lacquer dissolves plastic disposable cups?Me neither. By pure blind luck it wasn’t over anything important when the bottom let go. Anyway, I put the stuffer tube in. There’s no rear centering ring; the tube’s held in place with…
Add a comment...

Post has attachment
I gave the nose cone an Elmer’s treatment, then primed and started sanding. Discovered a problem. The sides weren’t as flat as I thought. This side had an especially low spot in the center, but really all the sides were higher on the edges. I did a lot of…
Add a comment...

Post has attachment
This is the last of the kits I bought at NARCON last year to be started. I’ve always liked the Blue Bird Zero’s looks and decided, standing there in eRockets, I should have one. I’ve since thought of a couple possible kitbash ideas, so maybe I should have…
Add a comment...

Post has attachment
It’s been announced that next Memorial Day Weekend, instead of their usual NYPower event, the Monroe Astronautical Rocket Society (MARS) will be hosting the NAR’s National Sport Launch in Geneseo, NY at the site of the National Warplane Museum. Well, add…
Add a comment...
Wait while more posts are being loaded