Profile cover photo
Profile photo
3D Lab Store
2 followers
2 followers
About
Posts

Post has attachment
Previously we introduced 3D printing speed setting, but actually there are several types of 3D printing speeds and today we are going to talk about this.

http://bit.ly/2fzsPRq

#3dprintingspeed #flashforge #flashprint #3dslicing
Add a comment...

Post has attachment
Last time we talked about the detailed settings of the treelike support in a 3D slicing software, and this time we will talk about the detailed settings of the linear support.

#3dslicing #flashforge #flashprint

http://bit.ly/2gmlt64
Add a comment...

Post has attachment
Previous we introduced the difference between treelike support and linear support in the 3D slicing software. Today we are going to talk about the detailed settings of treelike support.

#3dslicing #flashforge #flashprint #3dprint

http://bit.ly/2fxiwf2
Add a comment...

Post has attachment
You may encounter the situation that there is gap between 3D printout’s perimeter shells without overlapping. Today we will talk about what actions we should take to solve this issue.

#3dslicing #flashforge #flashprint

http://bit.ly/2fHbzJ8
Add a comment...

Post has attachment
When doing a big 3D print, there are some 3D slicing settings we need to pay attention. Today we are going to talk about this.

#Flashforge #flashprint #3dslicing #big3print #3dprint

http://bit.ly/2goL5QN
Add a comment...

Post has attachment
Generally, when we print a big sized 3d model, the choice of infill pattern will become more influential than when printing a small sized 3d model. Today we are going to talk more about this.

#flashforge #flashprint #3dslicing #infillpattern

http://bit.ly/2fYKvbK
Add a comment...

Post has attachment
Sometimes you may encounter a situation that a 3D model cannot attach on a print bed firmly. Actually there are some settings in a 3D slicing software that can improve the print bed adhesion. Today we are going to talk about this.

http://bit.ly/2fFbxCj

#3dprintbed #flashprint #flashforge
Add a comment...

Post has attachment
When 3D print either ABS or PLA, the settings in the 3D slicing software are different. Today we will talk about what settings we need to pay attention by using Flashprint 3D slicing software.

http://bit.ly/2fDQzHu

#3dwarping #3dslicing #flashforge #flashprint
Add a comment...

Post has attachment
You may sometimes encounter the warping issue during 3d printing. Today we are going to talk about what settings we should do in the 3D slicing software in order to minimise the warping issue.

http://bit.ly/2fjCB8E

#3dwarping #flashprint #3dslicingsoftware #flashforge
Add a comment...

Post has attachment
Previously we talked about the types of support and the overhang angle, this time we are going to talk about adding / removing support material in the 3D slicing software.

http://bit.ly/2dQ1XyH

#flashforge   #flashprint   #3dslicing   #3dslicingsoftware   #supportmaterial   #3dsupport  
Add a comment...
Wait while more posts are being loaded