Profile cover photo
Profile photo
Jeff DeMaagd
169 followers
169 followers
About
Posts

Post has attachment
I had worked on a few variations of water cooling in the past 18 months. A couple minor variants not shown.
PhotoPhotoPhoto
9/26/17
3 Photos - View album

Post has attachment
DuetWiFi before wiring was done.
Photo

Post has attachment
Nothing new lately but I can post a couple photos of Ultem 9085 parts I made a couple months ago.
Photo
Photo
5/31/17
2 Photos - View album

Post has attachment
I've done most of the installation wiring and some initial configuration on an Azteeg X5 GT. Maybe get it fully set up tomorrow night.
Photo

Post has attachment
I made a controller and fan mount assembly for my Azteeg GT X5
PhotoPhotoPhotoPhotoPhoto
5/10/17
7 Photos - View album

Post has attachment
Ultem Benchy.
PhotoPhotoPhotoPhoto
4/12/17
4 Photos - View album

Post has attachment
Small vase, in vase mode. Ultem 1010.
Photo

Has anyone here tried E3d's copper heater blocks? Do you notice a difference in how it works thermally vs. the aluminum blocks? Does the plating do a good job keeping it clean?

Post has attachment
I was asked to make rocket stls that worked well and got sidetracked. I redrew these retro styled rockets from scratch based on popular publicly available files, because the faceting on the original was awful. Also, experimented with vase mode.
Photo

Post has attachment
Back to HIPS support, it breaks out easier and more cleanly than using the native material for support. The gray is Atomic gunmetal gray ABS.
Photo
Wait while more posts are being loaded