Profile cover photo
Profile photo
Pierce Ferriter
54 followers
54 followers
About
Pierce's posts

Post has attachment
Anyone seen these http://store.3dracers.com/product/3d-printed-rc-car/ ? They are on a bit of a sale for next few days and tempted to pick it up. 

Post has attachment
Some volcano prints from this weekend, printed in 0.3/0.35mm layer height with the 1.0mm nozzle.. Still have issues with benchy where the top layers dont always stick to the sides properly but its looking much better. I prefer the volcano for vases at the moment due to the strength you get on the end part! Vases at 200% and 170%, benchy at 200% size :-D
PhotoPhotoPhoto
5/1/16
3 Photos - View album

Post has attachment
Not as good at Steve's that's for sure! Printed in just over 3 hours, 125% scale with volcano 1.0m nozzle, one perimeter no infill. Using e3d everyday white PLA at 195c. Not quite sure how to get the raft off... That might have been a mistake... 
Photo
Photo
09/04/2016
2 Photos - View album

Post has attachment
Some weekend prints. Using e3d's everyday pla. The headphones are the models from print.plus (another kickstarter, not yet available for pre order) 
PhotoPhotoPhoto
03/04/2016
3 Photos - View album

Post has attachment
Just a reminder, if you apply nut lock to the pulleys on each end of your y.. . You should probably do the ones where the motor joins to it as well... 
Photo

Post has attachment
Everyone loves a time lapse right? A chess piece and a vase
http://www.thingiverse.com/thing:18672 and http://www.thingiverse.com/thing:470700
Video
Video
3/24/16
2 Photos - View album

Post has attachment
Tonight's dual extrusion, have the printing doing what I want at last. Now to fine tune and adjust away the zits and alignment that is slightly off, must be 35mm and not 36mm difference! :-) 
Photo

Post has attachment
For those wondering how my dual printing is going... About 36mm to the right. Just found the setting in simplify3d that I hadn't checked as I was putting it all away! At least there is always tomorrow night
Photo

Post has attachment
Are these filament holders rated for zero gee? Just turned my printer on side and realised I forgot about the two spools on back... They were fine and still spin happily! 
Photo

Post has attachment
Well if we are printing benchy I may as well join in. Printed yesterday, today I have been trying to tune the printer for using nGen 
Photo
Wait while more posts are being loaded