Profile cover photo
Profile photo
CNX Tech
6 followers
6 followers
About
Posts

Post has attachment
Little more done. still chugging along
Photo

Question what power supplies are you guys using?

Post has attachment
Frame is coming along. Still probably a week for some of the parts. Most of the parts are designed. I ordered some collimators for the LEDs last minute just in case
Photo

Post has attachment
So far so good led array hardened couple drop of resin in about 5 seconds direct. Paper was used to show focal length. 109 LEDs. Any input is appreciated. Think I am going to be able to use the 12v power supply that came with LEDs to power everything and not use 20amp big power supply.
PhotoPhotoPhotoPhotoPhoto
8/12/18
6 Photos - View album

Post has attachment
Design is coming along. Should work up to an iPad screen size. All the dimples are mounting points. Can mount on inside or outside. Some larger holes are around the sides for wires. Each side is a frame and and insert. Insert is meant to be customizable. I will design wire management and standoffs. WIP
Photo

Post has attachment
Has anyone tried connecting 405nm led light strips to the bed output of a ramps board? Then wind them back and forth under the lcd going up the sides.

I am thinking about trying. If they do not work i believe they should be fine for a curing chamber and go a different route for my light source.

https://www.amazon.com/gp/product/B078SQZRYG/

Anyone know where directions are to recover from hard brick. I get nothing on display. I figure I'm going to have to solder on USB card reader. I just can't find direction for hd 7 2013 model.

Post has shared content
Looks like fullscreen! From the play store
Thanks to everyone in this community.  I have finally got my Kindle fire to work just like a normal tablet.
Photo
Add a comment...
Wait while more posts are being loaded