Profile cover photo
Profile photo
Joseph Pontone
92 followers
92 followers
About
Joseph's posts

LET'S GO METS

Post has attachment

Post has attachment
Animated gif at the white house press room. A great privilege 
Animated Photo

Post has attachment
2 miles above sea level never looked so good. animated! 
Animated Photo

Just loaded up my makerbot2 with flexible pla. While the instructions recommend 120c as the proper temperature, I don't get a good flow of filament unless i set the temperature to 135. Even  then, the filament tends to stop flowing after a few minutes. Any suggestions?

Post has attachment

Post has attachment

Post has attachment

Post has shared content
No liking unless you get it right away. But if you did, you should get this right away, too: http://po.st/QCv79Q
Photo

Post has attachment
Wait while more posts are being loaded