Profile cover photo
Profile photo
Kenming Wang
126 followers
126 followers
About
Posts

I have a terrible problem.
The BL-Touch I had installed and setup marlin firmware already.

I can normally run the G28/G29 command and I can use the M280 to test the BL-Touch signal successfully.

But When the BL-Touch standby, it repeatedly push-pull cycle about every 20 seconds.

My board is Ramps 1.4, and I am sure I had wired correctly.
What's the problem ?

Post has attachment

Post has attachment
PhotoPhotoPhotoPhotoPhoto
2015_0216_宜蘭一日遊
116 Photos - View album
Add a comment...

Post has attachment
0215/02/16 於春節前夕與蓁妮、荳荳、、姥姥、雨味一同到宜蘭一日遊。
PhotoPhotoPhotoPhotoPhoto
2015_0216_宜蘭一日遊
116 Photos - View album
Add a comment...
Wait while more posts are being loaded